The 32-bit entry sets EFER.SCE on its way into long mode. entry64uefi
skips that bootstrap entirely, because firmware has already done the mode
switch -- and with it skipped the one bit in there that is not about
paging. UEFI has no reason to set SCE and does not, so the kernel came up
with SYSCALL disabled.
Nothing noticed until the UEFI path first got far enough to run a user
program, at which point the first sysretq raised #UD: "unexpected trap 6
... rip <syscall_trapret>" in pid 1, at zero ticks.
Read-modify-write, because LME and LMA are already set by firmware and
have to stay.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
Every driver reached its registers with P2V(bar.base), which assumes the
BAR sits inside the 0-4 GB the direct map covers. Under SeaBIOS it always
does. Under OVMF it does not: firmware may place a 64-bit BAR anywhere,
and it puts virtio-gpu's at about 768 GB. P2V produced an address with no
translation behind it, so the driver's first register write took a page
fault, then a double fault, then a triple fault and a reboot loop --
which, coming from a driver bind, reads as broken hardware rather than a
missing mapping.
ioremap() carries each region on a 1 GB page in PDPT entries 4-511, which
were unused: the direct map occupies 0-3, and kpml4[0], kpml4[KERNBASE]
and every process's PML4 all share that one table, so a mapping appears
in every address space at once with no page table to allocate. The pages
are cache-disabled and write-through for the same reason the top GB of
the direct map is -- these are registers, and a write sitting in a cache
line is a write the device never sees.
A physical address below 4 GB returns the direct-map address unchanged,
so the BIOS path, where every BAR is low, is byte for byte what it was.
virtio-gpu now initialises under OVMF (1280x800, queue 64) instead of
triple faulting. e1000 and xhci had the identical latent bug; xhci was
already refusing to bind above 4 GB with a comment saying the mapping did
not exist yet, and now it does.
BIOS unchanged: bootcheck 108 [ok] with -Fb -Tty -Usb -Sock -Evdev -Ps,
e1000 and xhci both binding.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
e820_init() took the usable run *containing the kernel* and treated its
end as the top of RAM, and kinit1() walked a single range from the end
of the kernel image to there. That is the shape of a BIOS map. It is
not the shape of a UEFI one: OVMF places an ACPI NVS region at 8 MB,
so the kernel's run ended there, the map failed the PHYSTOP_MIN check,
and the kernel fell back to asserting 224 MB it had not measured --
then freed straight through the reserved hole anyway.
Keep the usable regions as a list as well as a top address. kinit1()
now frees each one, clipped to the window main() passes in, so the
holes are skipped rather than either freed or fatal. PHYSTOP still
means what it always did -- the top of what kalloc may hand out, and
the bound kfree() rejects pages above -- so no call site changes.
phystop comes from the largest region rather than the highest. The DMA
arena is carved off the top of PHYSTOP and must be physically
contiguous, and the largest region is the only one certain to have
room; a smaller region above it is left unfreed rather than raising
the bound past a hole, because kfree()'s check is worth more than the
pages it costs. Report the usable total separately from the top
address, since with a fragmented map they are different numbers and
printing one as the other is how 8 MB went unnoticed.
Verified on both paths. BIOS: unchanged at 1023 MB in 2 regions,
bootcheck 27/27. UEFI under OVMF: 1018 MB in 7 regions, up from the
8 MB that triggered the fallback, booting through vga, e1000, the RTC
and on to cpu0.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
Neither is Fedora-specific. A different host and a freshly built
userland simply drove code that Windows never reached.
tools/mkfs.c did not compile at all. The DT_UNKNOWN/DT_DIR/DT_REG
fallbacks sat above <dirent.h>, so on glibc -- which spells them as
enumerators -- the #ifndef asked before the header was read, always
answered "missing", and then the header's own enum expanded to
`enum { 0 = 0, ... }`. Move the fallbacks below the include. The
include cannot move up instead: it has to follow the #undef that ends
the `#define dirent schfs_dirent` block.
getstackpcs() page-faulted. It dereferenced rbp[1] without validating
rbp, and the guard rejected 0xffffffff -- dead code on x86-64, already
caught by the KERNBASE test -- while the value that actually turns up
is all-ones, which is above KERNBASE. rbp[1] then wrapped to 0x7 and
took trap 14. `cp` panicked the kernel every time. Bound rbp from
above and require 8-byte alignment.
That second one masks other bugs: getcallerpcs() runs on every lock
acquisition and again from the trap handler, so a walker that can
fault replaces a real diagnosis with a bogus one.
Baseline on the Fedora laptop is now green: make ports, make,
make schfs-check including the round-trip that had never run, and
bootcheck at 27/27 plus 108 [ok] across the extended suites.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
Loads the kernel from the ESP, places its ELF segments, records the
framebuffer, translates the UEFI memory map into E820 entries, exits boot
services, builds the page tables the kernel expects and jumps. Verified
under OVMF: the kernel starts, brings up PCI, VGA, e1000 and the RTC, and
reaches "cpu0: starting".
UEFI structures are written from the specification rather than importing
gnu-efi or EDK II -- a large dependency for two hundred lines of use, and
a licensing question the project does not need to answer. clang emits
PE/COFF directly, so this needs no new toolchain.
The kernel gained a second entry point. The multiboot entry is 32-bit
code that climbs into long mode itself, and firmware that already put us
there would have to drop back down only to climb out again -- a mode
switch whose failure mode is a triple fault with no console. So entry.S
publishes its 64-bit entry the same way it publishes the multiboot
header: a magic to scan for, SCH64BOO, with include/schboot.h owning the
constants so the two cannot disagree. That header goes *after* the
multiboot header, never before: header_addr says the multiboot header
lives at mboot_load_addr, and the BIOS loader computes the kernel's file
offset from it.
The kernel loads its own GDT at that entry rather than the loader doing
it. Arriving in long mode means arriving on the firmware's descriptors,
and the first thing depending on the kernel's own selectors faulted --
"unexpected trap 13 ... cs=38", a long way from the cause.
KNOWN LIMITATION, diagnosed and not yet fixed: e820_init takes the usable
run *containing the kernel*, which under OVMF ends at 8 MB -- the
firmware places an ACPI NVS region at 0x800000, so the run is genuinely
fragmented. The map is truthful and untruncated (21 entries); the
assumption of one contiguous run is BIOS-shaped. The fix is for the
kernel to free each usable region rather than one range, which touches
kalloc and deserves its own change rather than the tail of this one.
BIOS boot is unaffected: 27 checks, no failures.
boot/bios/ now holds the MBR, the El Torito stub and the real-mode stage
2; boot/uefi/ is empty and documented.
Separate directories rather than #ifdefs, because the two share almost
nothing. A BIOS loader lives in 16-bit real mode, reaches the firmware
through software interrupts, and walks itself up into long mode. A UEFI
loader is a 64-bit PE that the firmware has already placed in long mode
with paging on, calling services through a table of function pointers.
What they do share is the hand-off contract, which boot/README.md now
writes down: ELF segments placed, long mode, a 24-byte-entry memory map
at E820_MAP_ADDR, framebuffer geometry at VBE_INFO_ADDR.
That contract is the point of documenting it now. UEFI's GetMemoryMap
returns EFI_MEMORY_DESCRIPTORs, and the right move is to translate them
into the entries kernel/arch/x86_64/e820.c already parses rather than
teach the kernel a second format.
Build output paths under $(BUILD)/boot are unchanged; only sources moved.
Two bugs reported from actual use, plus a test harness that had stopped
testing.
init could be killed by Ctrl-C, taking the machine with it. SIGINT goes
to the foreground process group, init is pgid 1, and any window where
tty_fg_pgrp is 1 -- before a shell claims the terminal, after one exits,
or between the two while the key is held -- lands it on init. init has
no handler, so killed was set, exit() ran, and exit() panics outright on
initproc. Spamming Ctrl-C at a frozen program is exactly the input that
finds that window. POSIX and Linux both discard a default-action signal
for pid 1; init_ignores() now does the same, SIGKILL included, because
init is not killable from userspace on any Unix.
Everything was slow because BSIZE was 1024 while a SchFS block is 4096,
so every block cost four IDE requests, each with its own interrupt and
sleep/wakeup. exec() of the 800 KB toybox binary meant ~800 round trips.
The giveaway: `seq 1 200`, which touches no file and prints nothing,
cost the same 2.0s as `cat /bin/toybox`, and `ls | wc -l` cost exactly
double -- both dominated by loading the same binary twice.
BSIZE is 4096 now, one request per SchFS block, and NBUF is 256 blocks
(1 MB) rather than 90 KB -- smaller than the binary every command execs,
so nothing was ever still resident. ideinit() issues SET MULTIPLE MODE,
which is what makes a 4096-byte transfer legal: READ/WRITE MULTIPLE move
the drive's multiple count per interrupt and nothing had ever set it,
which is the real reason idestart() carried a sector_per_block > 7 panic.
seq 1 200 2.02s -> 0.06s
ls /bin 2.76s -> 0.68s
ls /bin | wc -l 4.68s -> 0.73s
And the harness. bootcheck called Find-Qemu from a param() default,
which is bound before any function in the body exists -- so it died on
its first line and printed an error containing neither "FAIL" nor
"Exception", the two things being grepped for. It had not run since it
was made host-portable. Worse, an earlier index-based edit had deleted
the Expect blocks for -Tty, -Usb, -Sock, -Ps and -Evdev, so five of the
seven modes asserted nothing at all. Restored, and the USB run gets its
own 16 MB build/usbstick.img: it had been pointed at build/fs.img, which
nothing builds since SchFS became root, so QEMU refused to start.
242 checks across seven modes, all passing, and make schfs-check green.
Removes the "-unix" element and with it any trademark exposure to The
Open Group.
The split follows the ecosystem layout: SchOS is the system, and the
kernel has its own name. Kernel-identity strings are the only places
that take SchIFT -- uname(2) sysname, /proc/version, and the two licence
sentences that say "kernel" outright. That is what every Unix does here:
`uname -s` on Linux reports the kernel, not the distribution. Everything
a user reads as the product -- panic screen, boot menu, error prefixes,
docs, LICENSE, NOTICE -- is SchOS.
schunix.img is schos.img, the logo assets and the musl TLS patch are
renamed, and __SCHUNIX__ is __SCHOS__ (the define and the patch that
consumes it moved together).
Two things the rename broke, both found by the bootcheck suite:
- shmtest wrote "SCHUNIX-MMAP-OK" with a hardcoded length of 15 and
compared it back by hand-counted offsets (m[3]=='U', m[14]=='K').
The shorter marker left the write running two bytes past the literal
and the compare reading past the data, failing a file-backed mmap
that was working correctly. Now written and compared through one
constant with sizeof.
- bootcheck asserted a 31-byte file after appending to
"hello-from-schunix"; the shorter string makes it 29.
Both are the same mistake: a string literal whose length is written out
somewhere else. Full suite green -- base, Tty, Ps, Sock, Fb, Usb, Evdev.
An x86-64 operating system built from xv6, now largely rewritten: SMP,
a copy-on-write root filesystem (SchFS), PCI/USB/virtio drivers, a TTF
rasteriser, and a Linux-numbered syscall ABI.
No history before this point -- the tree was never under version control.
This commit exists so the rename that follows has something to undo to.
